Replacement Lid Handle for NESCO MWR18-13, 6.5-Inch Hole Spacing, Screws Included

Product details

Replace a broken or damaged NESCO roaster lid handle without replacing the entire lid.

This durable 3D-printed replacement handle is designed for the NESCO MWR18-13 roaster lid with mounting holes spaced 6.5 inches center to center. Two compatible M5 mounting screws are included, so the handle arrives ready to install.

Product Details
One finished 3D-printed replacement lid handle
Two M5 mounting screws included
Overall length: 8.5 inches
Mounting-hole spacing: 6.5 inches center to center
Center grip width: approximately 1.375 inches
Maximum end width: approximately 2 inches
Color: Black
Made to order
Installation

Remove the damaged handle and clean the mounting area. Align the replacement handle with the existing holes and install it using the two included M5 screws.

Hand-tighten the screws until the handle is secure. Do not overtighten, as excessive pressure could damage the handle or roaster lid.

Verify the Fit Before Ordering

Measure between the centers of the two mounting holes on your lid. The measurement must be approximately 6.5 inches center to center.

Roaster models and lid designs can vary, so please compare the provided measurements with your original handle before ordering.

What You Will Receive
One physical replacement lid handle
Two M5 mounting screws

The roaster and lid shown for reference are not included. This listing is for a finished physical product—no digital files are included.

Minor layer lines and small surface variations are normal characteristics of 3D-printed products and do not affect normal use.

This is an independently manufactured compatible replacement part. It is not manufactured, sponsored, authorized, or endorsed by NESCO.

Need a different color or a custom part? Send me an Etsy message before ordering.